A professional odometer tool:PSA BSI tool

PSA BSI tool is professional odometer tool for Pegueot and Citroen. It can be used to read and write eeprom of BSI, programming new KM in BSI and so on.
Software version: V1.2

PSA BSI tool for Peugeot and Citroen Odometer

Note: when you do the odometer and it may takes about 1 hour,please do not off the power.

Version:1.2V

Software for downlaod:

Description:

1. Functions for Simens with CAN:
a) Read EEprom memory BSI
b) Write EEprom memory BSI
c) Read BSI flash
d) Programming new KM in BSI

2. Functions for Valeo and Johnsons Control with CAN
a) Programming new KM in BSI
b) Reprogramming flash for Johnsons Controls.

3. Operated models
1) Peugeot 207
2) Peugeot 307 from 2005- ...
3) Peugeot 308
4) Peugeot 407
5) Peugeot 607 from 2006-...
6) Peugeot 807 from 2006-...
7) Peugeot Partner III
8) Peugeot C8 from 2006-...
9) Citroen C2
10) Citroen C3 II
11) Citroen C4
12) Citroen C4 Picasso
13) Citroen C5 II
14) Citroen C6
15) Citroen Berlingo III
16) Lancia Phedra from 2006-..
17) Fiat Ulysse from 2006-. !

"PSA BSI Tool" Include hardware device and software, also user manual. You must connect hardware to PC before run the software.

If you want to learn more mileage program tools,pls check here!

Honda Accord sedan shift lever lock

A mileage of about 80,000 km, configuration K24A4 engine and automatic transmission, the Honda Accord sedan . The car had water due to engine overhaul , then auto diagnostic tools appeared the following symptoms : Start the engine , toggle lever , shift lever can not be linked into the D bits from the P position, the vehicle can not travel .

After receiving the car : use Mileage Program Tools diagnostic system for automatic transmission and engine systems diagnosis, no fault codes. See data flow engine system , the idle condition of the throttle opening degree is 30% , not normal ( normal should be about 9% ) . Disconnect the throttle position sensor 3-pin wiring harness plug, resistance measurements on the 1st and the 3rd between the terminals , as 9.9kΩ ( normal should be 5. 7 kΩ), the No. 1 and No. 2, the resistance between terminals 9 . 9 kΩ ( normal should be 5. 7 kΩ), between the 2nd and the 3rd terminal resistance is 1. 6kΩ ( normal should be 1. 1 kΩ). The above results suggest that the throttle position sensor to detect damage . Replace the throttle body ( throttle position sensor and the throttle body integrated , can not be replaced individually ) , commissioning , fault completely ruled out.

Engine inlet leading to the throttle position sensor damage . Water from the throttle shaft into the throttle position sensor inside , causing the Original Launch X431 Tool slide potentiometer resistance becomes larger , power system control unit according to the throttle position sensor signal to determine the degree of throttle opening is large, the engine does not idle condition . In order to protect the engine and automatic transmission, power system control unit sends a command signal , device control lever lock solenoid through the multiplexer control, the shift lever is locked in P position, the vehicle can not travel .